Do not mix wall tiles and floor tiles

The use of "unconventional" materials, such as breaking colorful flower wall tiles on the floor of the bathroom, and then putting the plain bricks on the wall, it looks different, but experts cautioned that: It is neither scientific nor safe. Wall tiles and floor tiles cannot be mixed.
Floor bricks have different water absorption rates
The interior tiles are divided into wall tiles and floor tiles according to the paving locations. Strictly speaking, the wall tiles are pottery products, and the floor tiles are usually porcelain products. Their physical properties are different. There is a big difference between the selection of clay ingredients and the firing process. The water absorption rate of wall tiles is about 10%, and the specific water absorption rate is only 1% of floor tiles are several times higher. The floor of the bathroom and kitchen should be laid with low water absorption floor tiles, because the ground will often use a lot of water to wash, so that tiles can not be affected by water vapor, do not absorb stains. Wall tiles are made of glazed ceramics and have a high moisture content. The back of the wall tiles is generally rough, which also helps the adhesive to attach the wall tiles to the wall. Tiles are not easily affixed on the walls. Wall tiles used on the ground will absorb too much water and become difficult to clean. It can be seen that walls and floor tiles cannot be mixed.
Before the shop should be leveling tiling should be cleaned before the ground, such as lime plaster on the wall, latex paint, wallpaper and other decorative objects, or dirt on the ground, be sure to clean, otherwise the cement mortar and the grassroots adhesion is not strong; In addition, If the wall itself has cracks, it should be properly treated before it can be tiled, so as to avoid future basic structural cracks caused by cracking or falling off the wall tiles; also, for the flatness or verticality gap is too large for the floor, wall, Also use cement mortar for leveling treatment.
Laying sequence is stressful. The floor tiles should be affixed from the inside to the outside. If the ground has a slope or there is a leak, you should pay attention to the direction of the drainage. The wall tiles should be laid from the bottom up. For the sake of beauty, the bottom layer of the bricks should be affixed. After pressing the tiles, press the floor tiles. When there are half bricks, you should try to place them below. In addition, a wall cannot be attached to the top at a time to prevent the tile from being heavy and causing it to fall.
Wall tiles should be fully soaked
Wall tiles have a high moisture content and must be considered when pasting. The tile base should be fully moistened before it is tiled, and ceramic tiles should also be soaked in water for at least 20 minutes before use. Otherwise, the moisture in the mortar is rapidly absorbed by the dried substrate and tiles and condenses quickly, which affects the fastness of the bond. Wall tiles will also absorb moisture from the cement so that the cement does not function as an adhesive. In addition, the water absorption rate of each type of wall tile is not the same, which depends on the experience to grasp.

Tiles Tiles Cement Homes Paint Lacquers Home Wallpapers TV Wallpapers Floor Tiles Kitchen Wall Tiles Fashion Small Bathroom Tiles Color Bathroom Tiles Bathroom Tiles Bathroom Tiles Tile Tiles Kitchen Tiles

Clay Series

Clay Series,Andrew Dice Clay ,Dice Showtime ,Dice Clay

Sandwich Panel Co., Ltd. , http://www.nbpaints.com