Explosion-proof energy-saving lamps are ideal for fixed lighting in hazardous environments such as petrochemical facilities, oil platforms, gas stations, oil pump rooms, and transfer stations. They are suitable for use in Zone 1 and Zone 2 explosive gas environments, as well as in Zone 21 and Zone 22 flammable dust areas. These lamps provide a safe and efficient lighting solution where traditional lighting may pose a risk.
**Key Performance Features:**
1. These lamps use self-ballasted energy-saving technology, consuming approximately 70% less energy than conventional incandescent bulbs of similar brightness.
2. They offer quick start-up, no flickering, high light efficiency, and long service life, making them an excellent choice for energy-efficient and environmentally friendly lighting.
3. The two-chamber flameproof design ensures enhanced safety, making them reliable for use in potentially explosive environments.
4. The lamp housing is made from lightweight aluminum alloy and coated with electrostatic spray, offering excellent resistance to wear, corrosion, water, and dust. This makes them suitable for use in harsh industrial conditions.
5. Customizable lamp protection covers are available to meet specific customer requirements.
**Installation Instructions:**
Before installation, determine the appropriate location and method based on the work site's needs. Measure the distance from the lamp to the power source and prepare a three-core cable (with a diameter of Φ8–Φ14mm) accordingly. Route the cable through a steel conduit for added protection.
To install, loosen the compression nut at the cable entry point (this is usually not tightened at the factory when shipped with a steel conduit). Insert the power cable into the internal wiring compartment, secure the connections, and then tighten the cable gland and lamp cover. Finally, fasten the set screws to ensure a secure fit.
When replacing the lamp, unscrew the Phillips screw that holds the lamp ring and turn it counterclockwise to separate the lamp ring from the transparent cover. Remove the old lamp and replace it with a new one. Reinstall the components carefully.
**Safety Warnings:**
1. Always disconnect the power supply before installing or maintaining the luminaire.
2. Only trained professionals should perform installation or maintenance tasks.
**Important Notes:**
1. When operating the lamp, the surface will experience a slight temperature rise, which is normal. However, the center of the transparent part can become very hot—avoid touching it.
2. When replacing the lamp, always use the same type. If you change the lamp type or wattage, make sure to also replace the ballast, capacitor, and trigger unit accordingly.
3. Regular inspection and proper handling are recommended to ensure continued safe and effective operation.
These explosion-proof energy-saving lamps are designed to deliver reliable performance in challenging environments while contributing to energy savings and environmental sustainability.
Electric Single Seat Control Valve
Electric Control Valve,single seat control valve,Electric single seat control valve,single seat control valve Electric,Control Valve Electric
Jiangsu Tanggong Automatic Control Equipment Co., Ltd. , https://www.tgcontrolequipment.com